Magnefast is easy to use
No scaffold/studs or tools needed to install, great for locations with difficult access, no hole-stud alignment needed, no panel gaps.
Introduction to Magnefast
Magnefast is a patented single sided attachment system for wear panels that uses high strength neodymium magnets to hold the panels in place.
Full coverage design
Lagging Design Engineered to Provide Ceramic Coverage Across Full Pulley Face Width
Edge Sealing – Increased Adhesion to the Pulley Shell
Increased Adhesion to the Pulley Shell A significant cause of ceramic lagging failure is lifting of the lagging edge due to corrosion occuring at the lagging pulley interface. This is more likely to occur in pulleys operating in wet environments and is mainly seen on Cold Vulcanised Ceramic Lagging (CVCL) applications. The cause is the […]
Increased tile adhesion
Increased adhesion strength Increased environmental resistance of bonds Design engineered to increase tile pullout force Ceramic Tile Bond Failure There are a number of causes of ceramic tile bond failure, including the following: The primer and adhesive systems that are used by most manufacturers of ceramic lagging provide a good initial bond when applied at […]
Magnefast Bulk Port Authority
This port facility is one of the largest in the world and handles shipments of iron ore, lithium concentrate and salt. In October 2019 a trial installation of the Elastotec Magnefast ceramic wear panels was put in place – this trial installation is still in service today. In December 2020 a chute with studded steel wear liners was relined with Magnefast ceramic wear liners.
Lagging Selection – One of the 4 Pillars of Lagging Performance
Lagging can be of good quality and application can be correct, but lagging can still fail and does. Everything seems right but the lagging still doesn’t perform to expectations. So why does this happen? It’s because the lagging selection is not right for the application.
Colliery Transfer Chute Diverter
Elastotec Magnefast Ceramic Wear Panels were chosen for the application in this colliery transfer chute as the use of studded wear panels would have been very difficult and time consuming to install.
Outdoor ageing performance of Elastotec Ceramic Lagging
Ceramic lagging is widely used in applications that require increased levels of grip and long service life.
Elastotec Extreme Rubber Lagging
Elastotec extreme diamond rubber lagging is designed for drive and non drive pulleys that require extended service life.
